Following on from my recent game at the club - putting on a 1930's Egyptian Undead game, it was clear to me the tabletop lacked a centre piece, namely a large pyramid!
The question was how to put something together in a reasonable timescale and at a reasonable cost! Flicking through eBay there were a number of excellent 3D printed 28mm pyramids but they are all pretty expensive and in my eyes their sizes, whilst good, were not Wow!
I managed to bag this one for a ridiculously low price of just over £15 plus P&P, some instances are being valued at nearly £70, so act boldly when you see a bargain!
| The Pyramid when it arrived |
A couple of points to think about if anyone is as foolish as me and tries to replicate this model. It's very big (I'm guessing each edge of the pyramid is about 50cm wide) and it comes in a lot of pieces! It took me a good 45 minutes to figure out how it all slots together, before I dismantled it all again and prepared it for painting.
| I opted to keep the hieroglyphic stickers that came with the toy, I'm thinking that if they look rubbish at the end I'll remove them and make some alternative strips to use. |
My first decision was to not paint the interior of the pyramid, this is a project that I'll save to later if it proves successful. Next I protected the stickers with masking tape before spray painting the model black using car undercoat paint.
I wanted a quick way to paint the stonework textures on the model and I remembered a can of Plasti-Kote spray paint I had in the Garage. This ws a very old can and it had seen better days - see photo!
This Plasti-Kote stuff takes 4 - 11 hours to dry according to the can, I was lucky that this November day was bright, sunny and slightly windy, albeit very cold. Six hours later I was able to pack the walls away ready for stage two.
| To be fair the spray paint did its job, before prematurely blocking up / running out of propellant! I managed to get all the external walls painted so job done. |
This Plasti-Kote stuff takes 4 - 11 hours to dry according to the can, I was lucky that this November day was bright, sunny and slightly windy, albeit very cold. Six hours later I was able to pack the walls away ready for stage two.
| Close-up of the finished painted walls, the spray gave the lovely texture to the model that the toy version did not have |
Look out for Part Two - when I pluck up the courage to shade, highlight and weather this super big model.
No comments:
New comments are not allowed.