Friday, 20 November 2026

Building a Tomb Kings Pyramid - Part Two

In this, the second part of a short series, I am adding some detail to the basic paint job that I have put in place on the Playmobile pyramid, to make it a suitable 28mm Tomb Kings / Egyptian Undead tabletop terrain piece.

I actually left the Plasti-Kote paint a few days to dry, just because I was busy doing other things. I wanted to add some shading and highlights to the pieces at this time. I used GW Skeleton Horde Contrast Paint to colourise the gaps between the pyramid blocks, this worked pretty well but again needed a couple hours to dry properly.

Close-up of a section of the pyramid wall that has had shading added to the block joints.

Painting all the joints got pretty tiresome very quickly but it was a job that had to be done. I also outlined the statue on the side of the pyramid to give some additional shading. 

I then painted the statue with GW Baneblade Brown Layer paint before dry brushing this with a cream coloured hobby paint to get additional relief and highlights. With the statue already covered with the Plasti-Kote paint this effect came out pretty well.

Statue on the side of the pyramid, painted and drybrushed.
You can also see the shading done to the pyramid blocks.

In the picture above you can see the hieroglyphs that are placed around the entrance to the pyramid, as hoped these look OK on the model, so I will not change these.

Overview picture of the wall section,
before spraying with Matt Varnish for added protection.


Now to repeat three more times for the other sides of the pyramid! Also for four wall end connector strips that need shading, drybrushing and varnishing...

Next time a few shots on the built pyramid plus details on how I dealt with the entrances on each wall - spoiler alert, I only have the supplied statues for three entrances so I need to scratch build something for the fourth wall... 

No comments: